E-11 build...finally completed

[Oevil1]

What's the ejector made from?

[/quote]

Pics please

Here's the pics you were after Cavalier...
First is the pvc from Bunnings for the ejector.


Next is the diameter of the electrical pvc from Haymans, the main body of the blaster...


As you can see they fit together perfectly...


Then I cut the ejector to the desired length, 115mm. I also cut slots to slide over the screws that hold the handle and magazine receiver to the pipe.

I also put a disc in the end about 3mm from the end to help hold the spring when that goes in.

Next I put tape on to get a nice helical line for the ejector details and go at it with the Dremel...

With a little bit more of a clean up it should look pretty schmik!


I hope this will be of help.