Friday 7-Sep-2012, 10:10 PM
(This post was last modified: Friday 7-Sep-2012, 10:17 PM by Plastic Sarge.)
Hey JOker, I got the effect with supercheap export brand flat black and mission brown pressure packs, randomly spraying all over the armour, then used black box wipes (like wet ones that remove paint) and wiped 99% of it back off again. It leaves dirty colours in all the low spots and makes the white a dirtier less glossy white.
Since these pics I used satin clear (cabots brand I think) in a pressure pack, and sprayed bits that needed sand, and threw sand on the clear, brushed most of it off, then cleared over to seal the sand on tight. Now I have a sandy kneww, thigh, shoulder etc. Looks good. Too much is yuck though.
The blast marks are just flat black with the edges wiped to remove the fuzzy overprayed edge.
Hope that helps.
Thanks for the invite Agent Smith, rotten timing, I'm off to Thailand for a holiday on the same day!
Would have been great as I'm in Chuwar just off the Warrego, only 50 mins from Toowoomba.
Since these pics I used satin clear (cabots brand I think) in a pressure pack, and sprayed bits that needed sand, and threw sand on the clear, brushed most of it off, then cleared over to seal the sand on tight. Now I have a sandy kneww, thigh, shoulder etc. Looks good. Too much is yuck though.
The blast marks are just flat black with the edges wiped to remove the fuzzy overprayed edge.
Hope that helps.
Thanks for the invite Agent Smith, rotten timing, I'm off to Thailand for a holiday on the same day!
Would have been great as I'm in Chuwar just off the Warrego, only 50 mins from Toowoomba.