Phantoms DLT19 rebuild .
#1
This is a rebuild of a flexible resin version of a Blastech DLT19 heavy blaster .
Due to the flexible resin used in the casting which makes it less prone to 
damage if dropped it unfortunately can't support its own weight along its 
full length , to counter this an 18mm aluminium inner barrel was inset over 
300mm into the receiver and run through to the muzzle , it has been joined 
to make it permanently one piece , most of the casting seam has been removed
and the butt plate grooves reworked .

[Image: tbkcSc5.jpg] [Image: HL8Xb4hm.jpg]

[Image: ucFdmfrm.jpg][Image: xixr3Awm.jpg][Image: wo9WjKJm.jpg]


[Image: NDzxFvOm.jpg][Image: Ics7yOGm.jpg][Image: vQVlRdgm.jpg]


[Image: LWbs5IYm.jpg][Image: If0aOPCm.jpg][Image: kbyTgixm.jpg]


[Image: uaXIYuXm.jpg][Image: zpid2RSm.jpg][Image: nomZzLGm.jpg]

[Image: BjhYvpPm.jpg][Image: PoatMzTm.jpg]

[Image: pq5mTLWh.jpg][Image: OML6mKMh.jpg]
DW2013GCSN13BN12
DW2014GCSN14BN13
              GCSN15BN14
Reply
#2
Very nice, that weathering is on point!
[Image: 53289799330_7946086c0f_z.jpg]
Reply
#3
Brilliant work...well done, can you make me one too ?
Reply




Users browsing this thread: 1 Guest(s)